When you're on the Capture Setting page, locate and click the 'Go to Capture Panel' button. This action will lead you to the Capture Progress page in Qmanager. To initiate capturing, just click the green button associated with the desired port you wish to capture from. As capturing is in progress, the button will transition to red. If you wish to stop capturing, simply click the same button.
1. Capture Preview
Preview of what is being captured. Information like the protocol/port, IP
address, and other data are displayed. Shows a 10-packet preview of what is being captured in the
selected port.
Go Back to Capturing Setup: Goes back to the capture setup page.
Open in New Window: Opens in a pop-up window, where you can expand the view such as
Statistics and Filter Information.
2. Port Action
Each cell represents a single port. It shows the capacity bar and percentage,
current capture file name, and start/stop status for each port.
Port # | Mbps: Clicking on this button will show the statics of the selected port in the Statis-
tics panel.Start Port # Capture: Start capturing on the specific numbered port. The button displayed as
green means that capturing is not in progress.Stop Port # Capture: Stop the current capture progress on the specific numbered port. The
button displayed as red means that capturing is in progress.
3. Statistics
This shows the RMON1-based statistics per port. It also includes counters and
percentage bar graphs.
Reset Statistics: Resets the statistics of all ports back to zero. When switched back to zero, the
statistics display will be empty until one of the ports receives a single packet.
4. Filters
The current filter setup, regardless of whether it is activated or deactivated, is displayed in this section. Scroll up or down in the panel to view the rest of the filters.